For dry well installation of the pump, the pump hydraulics are sealed on the medium side with a mechanical seal. For wet well installation of the pump, the bearing is sealed on the shaft side by a mechanical seal and the hydraulics on the medium side with a throttle bushing. This V series benefits from the modular construction of our pump model series. The hydraulic parts of the V series can therefore be designed in models HPK, NPK, NPW and KB and are available as metallic, as well as elastomer-lined pumps.
Model V1: with this model, the drive shaft is designed as one part. Installation depths up to 2500 mm from the lower edge of the installation plate to the middle of the pump housing can be realised.This installation type is suitable for wet and dry well installations.
Model V2: in a model V2, the drive shaft is designed in two parts having an intermediate coupling. Due to this design, installation lengths up to 5000 mm from the bottom edge of the installation plate to the middle of the pump housing is possible. This installation type is suitable for wet and dry well installation.
|Pumping flow||up to 2500 m3/h|
|Pumping height, single-stage||up to 60 M.FL.S|
|Pump rotational speed||up to 1480 min-1|
|Connection nominal width||32 - 400|
|Maximum operating pressure||10 Bar|
|Temperature of the fluid||70 °C|
|Pressure nozzle position||any|
|Corrosion-resistance with PH||0 - 14|
Сontact us We are here for you to advice regarding all questions about pumping technology. Having analysed your application characteristics, we will develop an appropriate solution for you. Contact us!